rgmsii.cn-久久婷婷五月综合实拍,国产精品白浆无码流出,精品久久久久久久无码,中文字幕欧美成人免费

                 Welcome to Dongguan pengshun electromechanical Co., Ltd!
                Contact us

                Dongguan pengshun electromechanical Co., Ltd

                Contact: Mr Ren

                Mobile: 13688997595

                E-mail:daniel@m.rgmsii.cn

                Contact: Miss Yu

                Mobile: 13590359548

                Tel: 0769-82581698

                Fax: 0769-82583077

                E-mail:carrie@dgpenshun.com

                Address: Room 101, Building 2, No. 14 Xinhe Shengfeng Road, Wanjiang Street, Dongguan City, Guangdong Province


                Industry
                Your current location is:首頁(yè)>>Industry

                Five points for attention in machining titanium alloy parts

                Release time:2018-01-23 11:40:54  Browse times:

                The characteristics of titanium alloys affecting turning and milling are as follows: Low density, low hardness, low thermal conductivity, high chemical activity at high temperature.What should be paid attention to in processing according to these points?Let us to tell you:


                1.Low heat transfer coefficient, that is, no heat transfer.During processing, heat accumulates on the surface of the workpiece,it is very easy to make the cutting tool temperature is too high resulting in a burning tool, so it is required that the cutting tool quality is good, and the cutting speed should be low (low speed, low feed).


                2.The cutting tool is best to choose titanium alloy special tool,if not, you can also use the carbide tool, the higher the hardness, the better, it is recommended that more than 55 degrees.Because the higher the hardness of the tool, the tighter the texture, the better the heat transfer effect.And try not to use coated tool,the titanium alloy material will react with the titanium in the coating, resulting in a sticky knife.


                3.In rough machining, the less margin is left, the better.Titanium alloy low density, low hardness, the material is very cotton, easy to happen  cutter back-off.It will only happen the cutting is not in place during rough machining, and will not occur overcutting.In order to avoid "cutter back-off" lead to the size not in place and repeated machining,leave as little margin as possible to improve processing efficiency.


                4.Cooling measures should be taken during processing,never dry cut. More attention should be paid to the fine machining of small trace cutting, titanium alloy particles with small particle size will burn at about 200 degrees. 


                5.Large plants where conditions permit usually use liquid nitrogen for processing cooling (liquid nitrogen at minus 170 degrees is converted into a gas at minus 50 degrees by a heat exchanger,spray directly on the contact area between the cutter and the workpiece),in order to improve the processing efficiency.


                More
                ?
                日韩精品人妻系列一区二区三区| 久久精品人人槡人妻人人玩| 国产网友愉拍精品| 亚洲AV无码片一区二区三区| 国产成人高潮拍拍拍免费看| 色欲网天天无码AV| 91看片欧美久久| 国产又粗又猛又黄又爽无遮挡| 无遮挡又黄又爽又色的动态图1000| 久久久一本精品99久久精品66|